a/v receiver: the center piece of
your home theater
The center piece, stereo or dolby digital?, the a/v receiver, the master piece in our home theater, know about it
The receiver serves as the control unit and the amplification center for your entire system (it's a "receiver" because it contains a built-in AM/FM radio tuner). If it lacks an AM/FM tuner, it would be an "integrated amplifier," or just plain "amp," for short.
In any case, the receiver and its remote control let you select which source to listen to (CD player, FM tuner, tape deck, VCR, or DVD player) or watch (if it's an audio-video receiver). When you press "CD" on the remote, the receiver internally switches its amplifiers to the incoming signal from your CD player, passes those signals through its control section (tone, balance and volume controls), then to its built-in amplifiers and sends the greatly strengthened audio signals to your speakers (and the accompanying video signal to your TV, if you selected "DVD" or "VCR" on an A/V receiver).
If you are going to buy an a/v receiver, you must choose whether to get a simple stereo receiver that has two internal amplifiers to drive a pair of speakers, or instead, an A/V surround-sound unit that will have a minimum of five internal amplifiers to drive five speakers in your room: the left and right main speakers up front, a center-channel speaker atop your TV, and two surround speakers on the side walls. The sixth or ".1" channel, as in "5.1," is for just deep bass and low-frequency soundtrack effects. That Low-Frequency Effects (LFE) ".1" channel is sent to your subwoofer, which almost always has its own internal amplifier. Surround-sound receiver also have internal digital decoders to sort out the DVD player's Dolby Digital or DTS digital 5.1-channel soundtrack.
By comparison, stereo receivers are blessedly simple-just two internal amplifiers, no surround sound circuitry, and two pairs of speaker output connectors for the left and right channels. That still appeals to lots of buyers. However, prices of surround-sound 5.1-channel A/V receivers have become so competitive that they cost little more than a basic 2-channel stereo model. So consider very carefully whether or not you're planning a home theater system for a future (or bigger) home or if you want plain ol' vanilla stereo. Moreover, if you think that at some point in the future, you might be persuaded by the sheer pleasure of surround sound then now is the time to go for a multi-channel a/v receiver.
The rated power output of the receiver's internal amplifiers, stated in watts per channel into 8 ohms, will ultimately determine the unit's selling price. The more power you buy, the more costly the receiver. But "solid-state" (transistor) amplifiers are very economical. You can find stereo receivers with 80 or 100 watts per channel for as little as $300. A/V surround receivers with similar power start at the $400 mark. Don't go cheap on the power: the greatest source of damage to speakers is using too small amplifiers to drive speakers at high volumes, especially when you might "crank it up" at a party. The amp runs out of watts, distorts, and the distorted signal burns out tweeters or woofers in seconds. And one basic truth, most consumers do not understand when they are shopping for amps and speakers: smaller speakers generally require more power-not less-to produce realistic volume levels than big speakers do because they use smaller woofers and are less efficient.
